Skip to content

Schneider - KNX Corridor presence detector FM - MTN6305-0019

Ref.: MTN6305-0019

Schneider Electric

Availability: In Stock Out of stock
Special Price: 208.80 € Regular Price: 208.80 €

Schneider - KNX Corridor presence detector FM - MTN6305-0019

68 mm flush-mounted diameter

Cover diameter 120 mm

KNX presence detector for flush-mounted installation in long corridors.
The presence detector detects the presence of persons even in the case of small movements.
Control of the lighting is carried out dependent on movement (2 channels) or additionally dependent
on brightness (1 channel) via KNX telegrams. If there is sufficient daylight, the lighting
is switched off or adapted to a detection brightness (constant light regulation).
Devices for heating, ventilation or air conditioning (HVAC) can also be controlled (1 channel).
The presence detector has two detection sensors (passive infrared), a brightness sensor,
an IR receiver and an LED to indicate a detected movement, in test mode indication of the
activated programming mode.
The presence detector can be used as a single detector or in master-slave mode. The setting
is carried out in the ETS.
The presence detector can also be set and tested without the ETS, but with the appropriate
remote control (available as an accessory).
Indoor installation on ceiling (IP 20) on flush-mounted housing with two screws.

 

Add your comment
Only customer are allowed to publish comment
Comments