Schneider-KNX-Valve Drive Controller-MTN6730-0002

 It is used to operate thermal servo-motors designed to control
control of hydraulic floor heating or cooling ceilings.
The actuator has 6 electronic outputs. Up to
connect up to 4 230 Vac thermal actuators or 2 24 Vac thermal
24 Vac thermal actuators to each output. Actuators
normally closed or normally open actuators can be
connected.
In addition, the actuator has 6 integrated temperature regulators
which operate independently of each other.
The correction variables of the controller outputs can be
connected internally to the actuator outputs, so that temperature
so that temperature control and servomotor actuation can be performed
can be carried out by a single device on the bus.
The integrated temperature controllers can send the
correction variable telegram on the bus and thus control other
control other heating or fan coil actuators.
The outputs are either switched (1 bit) or PWM (1
byte).
Each output is protected against overload and short-circuit.
All outputs can be controlled manually using
front panel pushbutton.
Panel mounting on rails.
The bus is connected via a bus terminal.